anybody know the length of a stock 300ex swingarm? thanks, nathan.

 

Short enough to lose. Ihave one in my garage but can't find it. In the rafters ladder outside but if you are still wondering Ill check tommorrow.

 

hahaha, thats funny. id still like to know if ya run across it. by the way, how do ya measure one? from center of pin to center of axle, er what?

-nathan

 

From end to end it is about 18'' not counting the clamp bolts for the adjuster. Center to center is about 15 3/4'',but keep in mind the chain tensioner is a cam and will probably change that number one inch or so. If you're wondering it doesn't bolt on the 400. I checked along time ago.

 

i was just thinkin earlier today about how difficult it would be to extend a stock swingarm. im a welder so i dont think it would be too tuff, any thoughts er ideas? thanks, nathan.

 

I have a ''HOME MADE'' plus 4'' on my banshee and it is now bent and twisted. I bought it on E-bay so I don't know who made it but it looked good when I got it. I personally wont go that route any more. Check around you should be able to find one for less than$200, and you'll have the stock one tosell or put on later.