Recon Hand Warmer Help
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I need some help determining which power wire (switched) to tap into for the power to the hand warmers. If anyone has installed hand warmers or other switched accessory on a Recon, could you tell me which wire and where to connect to it? Did you worry about waterproofing it?
#2
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
You can tap into the nuetral light or reverse light wire. Just do it on the positive side before the bulb, or the bulb will come on whenever the handwarmer is used( if you tap into the wires after the bulb). Those wires are powered with the key on at all times, the light only comes on when the switch makes a ground.
Put a 3 amp fuse in line with the handwarmer, just in case you get a short, itll protect the wire circuits, of the quad.
Put a 3 amp fuse in line with the handwarmer, just in case you get a short, itll protect the wire circuits, of the quad.
#3
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
i put spot light on my recon one time u can buy a power outlet like a cigerate liter and hook it to your batter and then have it stick out in the little hole were your seat latch is the put a plug on the hand warmers and run your wires under your seat so they want be in your way and u can put a switch on your warmers[img]i/expressions/face-icon-small-tongue.gif[/img]
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)