2007 Side Plastic
#1
2007 Side Plastic
Has anyone else had a problem with the side plastic falling off. Every time I ride even for a short time I have to snap the side plastic back on. The worst place is the left side(sitting on the bike) in the corner near the seat. Haven't heard anyone else mention having a prblem, maybe I have some bad pieces?
#2
#3
2007 Side Plastic
No problems here. Got to wonder if you are putting it on correctly. There is a slot at the top right that it has to go into, is it possible you have missed that??? The seat also helps to hold everything in place. Maybe replace the rubber gromets if they are deformed.....
#4
2007 Side Plastic
The side panels on mine fit fine, and I've had them off a few times installing accessories and changing oil. With the seat off, first be sure the tab at the bottom of the lower panel on each side goes into it's slot in the mudguard correctly, then there are four posts on each panel that need to be pushed completely into their rubber grommets. Then put the seat back on. If it still doesn't fit snuggly, I would concur with Reconranger, you must have some bad rubber on one or more of the fittings.
Thread
Thread Starter
Forum
Replies
Last Post
braap123
General RUV / UTV Discussion
0
09-07-2015 12:58 PM
braap123
General RUV / UTV Discussion
0
09-07-2015 10:57 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)