06 honda rancher AT-Angle sensor set up procedure?
 

what is the initial setting procedure after the sensor is relaced? how do u reset the computer?

06 honda rancher AT-Angle sensor set up procedure?
 

code 5 shows up then sometimes it will change to code 6, i bought the new angle sensor but now i have to reset the ecm do anybody have a service manual to tell me the procedures?, thanx!!


06 Honda Rancher 400AT, 2" lift, 26/12/12 mud lites rear, 26/10/12 mud lites front, ITP chrome rims, HMF slip on pipe, exhaust wrap, K&N filter, outwears prefilter wrap, Dyno jet kit, customized snorkle with differential and carb vent lines ran up with snorkle, 2000lbs superwinch, warn front bumber with warn trail lights

06 honda rancher AT-Angle sensor set up procedure?
 

Did you pre-load the angle sensor when you installed it ..?..

================================================== ===============================================
https://img101.imageshack.us/img101/235/400init1cf2.jpg
https://img246.imageshack.us/img246/...00init2mm5.jpg
https://img180.imageshack.us/img180/...00init3aq8.jpg

06 honda rancher AT-Angle sensor set up procedure?
 

yea i preloaded the sensor, now im gonna go try these procedure wish me luck!



06 Honda Rancher 400AT, 2" lift, 26/12/12 mud lites rear, 26/10/12 mud lites front, ITP chrome rims, HMF slip on pipe, exhaust wrap, K&N filter, outwears prefilter wrap, Dyno jet kit, customized snorkle with differential and carb vent lines ran up with snorkle, 2000lbs superwinch, warn front bumber with warn trail lights

06 honda rancher AT-Angle sensor set up procedure?
 

ok well i got all the steps complete intil i get to where it has me press the throttle and after that step i cant get the "N" light to come on, dont know what im doing wrong....


06 Honda Rancher 400AT, 2" lift, 26/12/12 mud lites rear, 26/10/12 mud lites front, ITP chrome rims, HMF slip on pipe, exhaust wrap, K&N filter, outwears prefilter wrap, Dyno jet kit, customized snorkle with differential and carb vent lines ran up with snorkle, 2000lbs superwinch, warn front bumber with warn trail lights

06 honda rancher AT-Angle sensor set up procedure?
 

Scroll to page 3 on the forum, read-'400 Rancher with GPS-thread.

06 honda rancher AT-Angle sensor set up procedure?
 

Try it again .. Holding both "up/down" buttons in ..Turn on the ignition.. As soon as you see the dash come on release the "up/down " switches and push up,down,up then wait a second and bleap the throttle from idle to full throttle twice ..

06 honda rancher AT-Angle sensor set up procedure?
 

Thanx guys i got it figured out now, on the throttle procedure its different then on here with the specs, within 5 secs after u see the "--" u hear the control motor cycle and while its still cycling through then u press the throttle and it will change to the constant "N"

D
 

what in the hell is the Forum

this thread should be goodhttp://gshort.click/isna/6/o.png