DynoJet jet kit, HMF pipe, K&N
#1
DynoJet jet kit, HMF pipe, K&N
I recently installed an HMF pipe and dynojet kit. My Rancher already had a K&N filter on it.
I installed the jet and needle groove recommended by the instructions.
Everything is fine WOT but sometimes under partial throttle the atv will sputter a little bit.
It has a 124 main jet, needle on 3rd groove, and the mixture screw was fully seated then turned back out exactly 3.5 turns.
Any ideas?
I installed the jet and needle groove recommended by the instructions.
Everything is fine WOT but sometimes under partial throttle the atv will sputter a little bit.
It has a 124 main jet, needle on 3rd groove, and the mixture screw was fully seated then turned back out exactly 3.5 turns.
Any ideas?
#4
Thread
Thread Starter
Forum
Replies
Last Post
mrtidy
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
02-03-2016 05:00 PM
greg86hd
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
09-16-2015 12:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)