Help on 02' 250EX axle please
#1
Help on 02' 250EX axle please
Hi everybody! First off, this is by far the best forum I've ever used. The information on here has helped me with my project so far, and now that I'm a member, I hope to benefit others with my knowledge!
But besides that, I just swapped in a new axle along with new differential and axle bearings and seals; and on the left side (when facing the rear) the wrong seal and collar were put in. I found the seal in the diagram of the swingarm, but when I went into Honda to order all the parts they said there were no other pieces besides the seal (excluding snap-ring and bearings). A picture on another forum showed a collar on the axle, so now I'm confused. I'd like to get this figured out and done right so help me please.
Thanks everybody!
(I have two pictures on my desktop but it asks for a url when I went to put them in, so no pics)
But besides that, I just swapped in a new axle along with new differential and axle bearings and seals; and on the left side (when facing the rear) the wrong seal and collar were put in. I found the seal in the diagram of the swingarm, but when I went into Honda to order all the parts they said there were no other pieces besides the seal (excluding snap-ring and bearings). A picture on another forum showed a collar on the axle, so now I'm confused. I'd like to get this figured out and done right so help me please.
Thanks everybody!
(I have two pictures on my desktop but it asks for a url when I went to put them in, so no pics)
#3
#7
Trending Topics
#8
#9
Since I have people looking at the thread and Im sure it would be better not to start another thread, I have one more question.
I put 300ex front shocks on my 250ex a month ago and they bolted up perfectly fine upside down so I left them like that. The information I found on doing this said it doesn't matter, and some said its bad for them. What would be best to do? I can fabricate them to work so what would be the best to do?
I put 300ex front shocks on my 250ex a month ago and they bolted up perfectly fine upside down so I left them like that. The information I found on doing this said it doesn't matter, and some said its bad for them. What would be best to do? I can fabricate them to work so what would be the best to do?
#10
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)