Southwick is GNC racing, not GNCC. I have to travel quite far to race. Hopefully they will get a race a little closer north. They went to Texas, now let's go to New England.

 

Those are 22" rears (only measure a little over 21). I put 23 in the front so I can run the suspension a little softer, but not loose ground clearance. I will see if this works, if not, I will go back to 22. The front's measured about 22 1/2". One thing I did notice, those Razr's are heavy. Even with the Hiper rims, they still weighed 2lbs more then the stock tire. The Razr's are a very rugged tire. Maybe that's why there the most expensive.

 

OMG![img]i/expressions/face-icon-small-shocked.gif[/img] How much money have you got sunk in the beast?! It's a beauty! How much was the Denton damper and do you think it would fit on a P650/700?

 

Quad looks great. I just got done installing my Elkas, Yoshimura dual exhaust, and Penland Brothers tie rods. Tomorrow I do the Dalton clutch kit, K&N, and mess with the jetting.

 

Pics look good....

Be safe racing good luck[img]i/expressions/face-icon-small-smile.gif[/img]

 

Nice rims[img]i/expressions/face-icon-small-wink.gif[/img] where did you get em? hehehehe [img]i/expressions/face-icon-small-happy.gif[/img] im glad your happy, now go beat the hell out of that v force!!! [img]i/expressions/face-icon-small-happy.gif[/img]

 

I got them from here Best I found on Hipers Service and shipment was top notch. If anyone once Hipers, this is the place to get them.

 

Way more then my wife would like to see in it lol.

As far as the dampner, I could not tell you. Denton Racing should be able to get one for the Prarie. It was $139.

 

The V looks great. Which GNCC's are you planning to hit?

 

I have 6 on the list to hit. NC, VA, PA, OH,MD,and WV.

By the way, congrat on your win in Texas. You shouldn't get any flats in Florida.