I can believe you guys cant get ur 360 up. All I do is put 1 foot on the back racks at a dead stop pull back a bit and it comes right up. Fully stock 360 too. I can ride it for about 10 ft but after i practice a little more I could prolly do it longer. I will try 2 get some pics up of be bringing it up.

Cody

 

It is not all that hard to do it on smaller atvs....just have to know how to do them... I can do it on the trailblazer and go about 30-40 feet but it is really hard because the thing almost has like no balance point...

 

The p360 doesnt really have a balance point either.

 

They all have a balance point. I was tuning up a budd's sportsman 90 for his son and pulled several 30 - 50 foot wheelies on that. Should get pics and post them, buddy was laughing so hard he nearly pee'ed his pants!! Imagine 5'10", 250 pound guy wheelieing a Sportsman 90 down street for 50 feet, as Larry the cable guy would say, " I don't care where your from,that's funny right there!!"

 

have you ever tried to disconnect the govener and then undo the throtal screw...that thing can actaully get some good speed!!

 

Hey--my nephew and ridin buddy has a Polecat 90---just installed a headlight in the handlebar pod last night for him (hope it doesnt burn up the generator) I have the throttle screw out and the hole siliconed, but didnt know about the governor?? DO TELL!!!

 

i can do it on my friends ozark 250.... while sitting on the seat

 

Moses, if you look under the front end and locate the cdi box,pull it out from the rubber mount and flip it over. You should see 2 screws and a little jumper plate under them. Remove the jumper plate and replace the screws. That little bugger will really rip now!

 

Thanx hellyea----should make for some interesting riding this weekend--