Tranny kits for the v-force
#1
Tranny kits for the v-force
I picked up the new V-force yesterday and finally started a little break in today. I bought it for my son to ride in the dunes and for my wife to ride around the house. I might have to go get another one for myself. This is my first auto tranny quad. Not all that excited with some of the chararistics of the auto tranny. What mods are availible for it. I am a little surprised at how much it revs up to cruise at a slow pace on a flat trail. I am pretty sure that i am going to buy a second one real soon and build it for flat drags. A turbo has a nice ring to it.
#2
Tranny kits for the v-force
Check with www.rittercycle.com they sell Dalton clutch parts for the V. I don't know if they have a spot on their website listing the parts for the V yet, but they have contact information there.
#4
Tranny kits for the v-force
Hey 14mins, go to kawieriders and go to the V force forum.
There are quite a few drag racers on there.
Some guys are running mid 5's in 300ft with a stk engine (with Nos, struts and wheelie bar)
Our V runs low 5's on pump gas with stk suspension (strapped down, but still big time wheelie problem)
Hope to have time to replace the shocks with struts, add a wheelie bar and 10-15 more HP this week. We should get well into the 4 sec range in 300ft and close to mid 3's in 200ft next weekend.
Dynoray
There are quite a few drag racers on there.
Some guys are running mid 5's in 300ft with a stk engine (with Nos, struts and wheelie bar)
Our V runs low 5's on pump gas with stk suspension (strapped down, but still big time wheelie problem)
Hope to have time to replace the shocks with struts, add a wheelie bar and 10-15 more HP this week. We should get well into the 4 sec range in 300ft and close to mid 3's in 200ft next weekend.
Dynoray
Thread
Thread Starter
Forum
Replies
Last Post
Lou Domenech
Classifieds, Garage Sale & Swap Shop
0
09-11-2015 06:35 PM
Logan Collins
Classifieds, Garage Sale & Swap Shop
0
09-05-2015 08:03 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)