BF750 after deep water ride.Any special maint?
#1
BF750 after deep water ride.Any special maint?
After riding in Azusa Canyon, Ca (Lots of deep water crossings) Is there anything I should do as far as after ride maint?
I flipped through my manual but didn't see anything. Any of you BF folfs have any quick tips? Thanks Calvin
I WANNA RIDE!
I flipped through my manual but didn't see anything. Any of you BF folfs have any quick tips? Thanks Calvin
I WANNA RIDE!
#2
BF750 after deep water ride.Any special maint?
You may want to check your front and rear differentials. Just to make sure you didn't get water in your diff fluid if you did it'll look milky. Not a big problem usually but you may want to check. If the water was muddy or sandy you may want to wash out the brakes real good. Don't use a pressure washer because it could push trash into the wheel bearings. A water hose with moderate pressure will work fine.
#3
BF750 after deep water ride.Any special maint?
Yeah I would check you fluids and makes sure there is no water in any of the oils. Also pull your belt cover and check for mud or anything like that. You have diaelectric greae on your electrical connections right? If not do it now. You will get corrosion. If your 2wd-4wd lite flashes in the next couple of day or so start with your fuses and then move on to other connections.
I always carry extra fuses... and not in the bike because those get wet also. Put them in the truck or something so if your get corroded up you can change them out easily.
I always carry extra fuses... and not in the bike because those get wet also. Put them in the truck or something so if your get corroded up you can change them out easily.
Thread
Thread Starter
Forum
Replies
Last Post
Customer Service #1
Arctic Cat
73
05-15-2020 08:46 AM
jrooker6
Polaris
18
04-23-2016 07:36 PM
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)