Anyone have to change there oil yet on their KFX and know how to do it! Thanks!

 

you dont have a manuel????

i'll quickly tell ya what to do.

1.let bike warm up for 10 minutes. then shut it off.
2. remove drain bolts from the bottom of the oil tank and engine.
3. drain all oil out ( i like to lift the bike up from the back and front, seems to p*ss out a lot more oil)
4. remove cover for oil filter (right side of the bike, lil 3 bolt cover) remove old filter, insert new one (MAKE SURE YOU LOOK AT HOW THE OLD ONE WAS IN THERE, so you dont put it in backwards and blow your engine and pour some oil on the filter before putting it in)
5. put both drain bolts back in
6. Put in 2.2 litres of oil in the oil tank. let the bike sit for a good 5 minutes then start it.
7. shut it off and check dip stick, make sure you got enough in it.


use 10w40 ATV oil. I use AMSOIL 10w40 synthetic.

 

I sent you a private message, but DVXDUDE seems to have you covered on how to do it. I imagine you were successful?

 

Thanks DVXDUDE and scottphillips88 i am trying the oil tomorrow afternoon i will let you know how it turns out! Thanks again guys!

 

Quit question i did the oil change on the quad where should i of put the oil? I put most of it in the place where the dipstick is and a little on the left side where that allen key bolt is! I hope thats how you do it lol

 

ya you put the oil in the oil tank where the dipstick is.....left side where the allen bolt is???

 

on the left hand side of the quad on the engine there is a allen bolt you can take out of the engine so i put some oil in there.