Help...I've brought my P360 2007 in for the 100 hour servicing. The bike clock was at 106 hours but the standard 100 hour steady on light still had not come on. I brought it in anyways for the check up and now the service centre states that when they reset the system the bike immediately went into limp mode and they can't get it to turn off! They've had the bike for 2 days and I just found out that they can't correct what ever happened so far? The bike was fine when brought in...the check belt light was not on, and has never flashed. They reset it and now it flashes and is in limp mode....big step backwards eh?
Any ideas?

 

Are all the wires plugged in?

 

Harry,
Read my PM.

 

<div class="FTQUOTE"><begin quote>Originally posted by: Hayashi

Harry,

Read my PM.</end quote></div>


Huge Thank you for the support.
The dealer finally figured it out and will not charge me. He states that it required the kill switch to be turned on in order to clear the code.
Thanks again

 

In my seaches on this site you mentioned that the P360 procedure to turn of the check belt light steady on reminder ...had a different procedure in 2007 models of the P360. Do you know what is different?
I still haven't picked up my bike yet from the dealer but when I spoke to him on the phone on Friday he said that the mechanic had to use the kill switch to clear the code? or something like that. The standard procedures that I have seen on the net don't mention the kill switch. Is this what is different?
Can you tell me where to get the 2007 P360 procedure then?

Dave P

 

I already sent you the procedure in my previous PM to you.
It is the step #4 that is different from other years.