I'm getting up in the years 67 now I needed help getting to the woods did some trading ended up with 360 Kawasaki and it runs after putting on a new clutch there are no sensors for the belt the belt light is on it starts idles but can't give it to accelerate it just misses
Is there a simple way to bypass the belt sensors

 

Is there an belt light on?

 

Found this procedure. I have never done it.

(it has to be reset.just follow the two wires that come off the little box at the top of your belt drive plastic and undo them at the plug.then you need two wires to cross connect them.then turn your key on for 10 secs.turn back off and reconnect them properly)

Didn't find anything on bypassing it. What year?

Is that the only light you have? will it go into and out of 4x4?