I just got the D&M kit for cannibal and found that I have a "Injector A open fault", any suggestions?

 

Check it again if its clear your good if not make sure the connections are clicked in the whole way. If that don't work get a voltmeter and check the voltage in them using the manuals located here http://www.cannondaleriders.com/tech/index.shtml. if that doesnt work check down inside the connectors to make sure the little tabs arn't bent. hope this helps!

 

If it runs fine and the fault is not consistant it might just be a glitch . I had mine do that once. If it is consistant then check the connectors for damaged , bent pins or corrosion. Quite a few have gotten this code after an engine install. Those little connectors have to be treated with respect. Do not force them on.