As stated from the beginning, I'd just like to debate this issue and it seems to be going along in fine manner.

Again, certaintly all valid points. I've never disagreed with any point you've brought up, rather sometimes I may have a different view. I would be interested in trying to get one set-up sometime. I think that the total cost may be slightly higher, probably closer to $1000 USD, then throw in the fabrication for the pipes. Perhaps my retort about tuned length was slightly confusing, I meant, yes you need to get that 25mm, so it's important to be done, whereas when I re-read it seemed like I said you'd be cutting shorter.

Email me at dunatic@hotmail.com about the tranny.

Thanks for the opportunity to learn more and have a decent debate about decisions to do motor conversions. Good day!!!

 

RZ cylinder pics are posted on my site at:

http://homepages.ihug.co.nz/~crainic/INDEX.htm

pages seems a little slow to load ?? so grab a beer and check em out.

Craig