Does anyone know where I can get some kick butt rear hubs for my Scrambler. They have to be Honda bolt pattern. I have a set that come from Rath Racing when I bought my fiber wheels. They were made for the Predator, but when on and worked for about 6 months a casual riding. Now they have stripped out and I would like to have some made for the Scrammy.

 

These MAY work. I don't know too much about them. You should give them a call to find out more

 

What are you looking for an 8 inch wheel if so some golf carts use the same 4x4 bolt pattern and are 8 inch. I run 4 Snows on mine to drag with...

 

I am not looking for 8 inch wheels, rather looking for hubs. The only way that I could Carbon Fiber wheels on my Scrammy was to change the hubs to Honda bolt pattern. When I bought the wheels they sent them wuth a set of hubs from Rath Racing. I put them on and they seemed to fit ok, but I had to modify the castle nut on the end of the axle to make them work. The hubs were deeper than the stock ones, so I had to grind the slot in the end of the nut a little deeper to make the cotter pin fit into it. I would prefer to have a set made for a Scrambler but may not be able to. I just hate to pay another couple hundred bucks on billet hubs if they are going to wear out that quick. I mostly just trail ride with a little bit of jumping and can't justify spending the monet every six months with the moderate jumping that I am doing. The hubs are billet and look like they are made to take some abuse, but they just did not in my case. Any suggestions from anyone is greatly appreciated.

 

your on the right track with your mods. adding power and lightening it but i would take that fmf pipe off and go with a hpd, rcr, or hotseat unit they are all far superior to fmf.

 

ATV junkie go to durablue web site, they make make them. My brother (naturalite) just bought them for his scrammy with the honda bolt pattern. I wanted a set for my DS650 but they don't make they for it. I think he paid like $179.00 for the rear set only.
Later!
Joe

 

You might try calling rath racing and see if they will replace them. Some one on here was bragging about how good of a company they were because he broke something from abuse and rath gave him a new one no problem!!!!