chrome-moly a-arms
#1
chrome-moly a-arms
I'm thinking about making some for my scrammy.they dont look to hard to make,anybody know the exact size steel needed?the only part i might have trouble with,is the end that the ball joint goes through.anybody know what someone like dennis from azbadboyz uses for the end?anybody that could post some close-up pics of the a-arms,id appreciate it..oh yeah,wondering about the gun drilling of the shaft,does it weaken it much?recomended for hard trail riding?thanks for any info..
#2
chrome-moly a-arms
I was thinking about making some new A-arms myself but no so much for light weight i was looking to get it a little wider. On the piece that the ball joint goes through i was going to cut the one off the stock A-arms and weld it on the new ones. I'm not sure about the gun drilling of the shaft but i would think that you wouldnt lose too much strength but i have no experience in that area.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)