I ordered a new CPI inframe drag pipe for my race mod and I was wondering since my bike is lowered for drag racing, how much clearance is there between the pipe and the right front tire? Does the pipe stick out of the frame very far?
Thanks!

 

It sticks out pretty good but I've ran it lowered way down and without front springs for drags a little and it doesnt hit. It is kinda tricky to get it to fit in the frame and turn right in there. It just doesnt look like it fits but it finally turns where it works just right. And it runs good too. good luck.

 

Thanks ALOT, I need all the luck I can get.

 

Boy have I learned alot, read my clutching basics thread I really got a nice hole shot after getting the basics down.

 

I emailed CPI about my pipe to see what the RPM range needs to be for the pipe to perform the best and they replied with a 6800-6900RPM. I didn't mention that I had race porting done, that should change it to about 7500-7800 shouldn't it? Please correct me if i'm wrong.

 

nah,the person wasn't the right one you might talk to cayze i known for real from
the builder himself the CPI pipe peak AT 7600 RPM,no bulls!

 

Thats what I thought, I was hoping that someone was mixed up or didn't know.