the piece you see is a piece of 2-3/4"o/d x 2"tall piece of pipe,with a piece of 1-3/4 o/d x 3"piece of pipe welded in side of it then cut in half..pull the spring down and insert the 2 pieces and release the spring..the inside piece sticks down an inch down into the spring so the 2 pieces are held in by that..the pic of the spacer is the last one in the address attached,hope this helps and let me know if you have any questions..also i did this on the top of the spring where most other lifts are on the bottom..it doesnt matter as either way your loading the shocks more..i also left the struts all the way down in the casings.so i didnt change the angles on the c/v`s much more than stock angle
topic title edited by atvbbs to remove personal addressee. use e-mail option for personal messages

 

bowtiepu1,

I hate to be the barrer of bad news, but in your photo album, the picture of your spacer/lift is simply just another nice red X. At least it is on my computer.

Dodgeram01

 

The picture is there Bowtiepu1. Nice mod.

 

It might just be my computer, because I still can't see that picture. All of your other pictures are there though.

Dodgeram01

 

dodgeram01, you need to click on that X and the full size picture will pull up. I have an X on that main screen too.

 

I can't pull up the pic either! Nothing..

 

I can see! I can see!
I don't know why, but now I can see the picture. Thats a nice pic.

Dodgeram01

 

Thanks for the Pic! That was awesome!! Now I have to have one!

 

they`re quite simple to make and install..i even had a few buddies from the garage say i should have marketed it,but i got the info from others and i figured why not give it back,ive learned from others on the forums so i hope it helps

 

looks great now how about selling me a pair???
if you are interested in making another set I would be willing to buy