OK - where are the zerk fittings?
#3
My 06 500 has 5. At the bottom of each front strut, Lower rear a arms and the front drive shaft slip yolk and that is the hard one, you will have to remove the foot board, turn the shaft till the zerk is facing the brake pedal, the hose will not fit sraight on it so you will have to hold it no tight and it should go. The 700 might be different but it will give ya an idea what to look for.
#4
#6
this helped alot thanks, but theres three, you forgot to mention that there are two struts not just one.
#7
Trending Topics
#8
My 06 500 has 5. At the bottom of each front strut, Lower rear a arms and the front drive shaft slip yolk and that is the hard one, you will have to remove the foot board, turn the shaft till the zerk is facing the brake pedal, the hose will not fit sraight on it so you will have to hold it no tight and it should go. The 700 might be different but it will give ya an idea what to look for.
Try picking up a 90 degree adapter for your grease gun that's what I use takes minutes and you don't have to remove anything .
#10
I'll look again but I know I've done this several times already.....