1996 250 trail boss drive clutch mounting bolt size
#1
1996 250 trail boss drive clutch mounting bolt size
This is an unusual question to ask but very important for me to finish swapping these motors . . .
I am putting a 1996 Polaris trail boss Fuji 250 engine in a 2000 Polaris xplorer 250 4x4 replacing the non running Robin 250 engine. Everything is "plug and play" very easy swap to do except I dont have the bolt that holds the drive clutch for the Fuji.
I have the bolt that was on the broken down Robin engine but it won't thread into the Fuji crankshaft so I am unable to install the drive clutch.
Was there a change in bolt size for the drive clutch when Polaris went to the Robin engine?
Can anyone tell me the size of the drive clutch bolt for the Fuji engine?
Can anyone tell me the size of the drive clutch bolt for the Robin engine?
I am putting a 1996 Polaris trail boss Fuji 250 engine in a 2000 Polaris xplorer 250 4x4 replacing the non running Robin 250 engine. Everything is "plug and play" very easy swap to do except I dont have the bolt that holds the drive clutch for the Fuji.
I have the bolt that was on the broken down Robin engine but it won't thread into the Fuji crankshaft so I am unable to install the drive clutch.
Was there a change in bolt size for the drive clutch when Polaris went to the Robin engine?
Can anyone tell me the size of the drive clutch bolt for the Fuji engine?
Can anyone tell me the size of the drive clutch bolt for the Robin engine?
#2
Thread
Thread Starter
Forum
Replies
Last Post
JOE3824
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
7
02-01-2016 02:52 PM
VilentJ
Performance Mods and Project Quads
6
06-26-2000 07:08 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)