96 425 Magnum
#1
96 425 Magnum
What would this machine run like if the Cam was bad? I have been trying to figure out what is going on with it and I finally pulled the valve cover. when turning it over the intake valves seem to move alot more than the exhaust valves. I am just wondering if the cam may be the problem. What are the distanced that the valves should travel so I can check them? I have heard that cams were a common problem in these years of polaris's.
#2
96 425 Magnum
I have a 95 425 magnum and your problem sounds like my old problem. You stated before that your limiter switch was maybe bad, I thought mine was the same problem until I clipped the green wire from the reverse overide button and it fixed all my problems. The mechanic at polaris said sometimes it will mess up and cause different problems.I am sorry it took me so long to tell you before you took your motor apart. Hope it works.
#3
Quad Patrol
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
1
09-09-2015 06:57 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)