RPM for a Banshee
 

Hey guys, Whats the Red Line for a stock Banshee? I hears a raptor was 9000, and 9500 with a pipe. Is it around 11,000?
Thanks
Ed

RPM for a Banshee
 

It depends on what type of pipe you have.

RPM for a Banshee
 

Ok beings i said STOCK......But anyway....a stock pipe...and a Toomey T5 or T6 set up....

RPM for a Banshee
 

ide guess 11,500 stock, maybee 12,500 on a T5 and 13,000 on a T6.

RPM for a Banshee
 

Just a little info. A stock Banshee wont pull more than around 8500 rpms. Even with pipes and no porting it wont make power past that point. My Banshee made it's max power at around 9200 on the dyno and fell off sharply at 10,600. That's with CPI pipes,porting,35.5 carbs,etc.

RPM for a Banshee
 

sory for misleading info, it sounds pretty fast though [img]i/expressions/face-icon-small-smile.gif[/img]

RPM for a Banshee
 

for any bike to rev at 12,000 rpm is incredibly fast. even the new 450s don't reve past 11,000 and with an aftermarket CDI i think the most they rev to is around 11,500.

RPM for a Banshee
 

your about right on but if you want to get close to 1000 more rpm get an offset flywheel key a couple more horses and more rpm

RPM for a Banshee
 

I didnt have time to list it all, but it is advanced 7 degrees, and on straight 110 race gas. It is not ported for all out top end, but I do have it set at 196 degrees on the exhaust and that makes good decent top end.

By the way Trey, if you ever decide to port your Banshee you will have to lose those T6 pipes. They suck with ported jugs.

RPM for a Banshee
 

yeah unfortunatly that is what i hear, and that is something that I am prob going to do, the T5 works well with those mods though doesnt it, but I am thinking Paul Turners are the way to go