thumb throttle, 2 wires in it?
#1
thumb throttle, 2 wires in it?
well i was fiddling with my thumb throttle and i saw a yellow wire with red stripe.. and a solid grey wire.. i was wondering if any one knows what these wires are for? and are they supposed to be there. it looks to me like it is.. when i hook a voltmeter up to them i dont see any current going thew them.. the brake light dosent work.. and no headlight but when i hook the VM up to there still no current runs great though.
any ideas? it is a 86 250R Quadracer
Thanks
any ideas? it is a 86 250R Quadracer
Thanks
#5
#6
thumb throttle, 2 wires in it?
I already PM you, but for the enlightenment of others I will reply.
The 2 wires running to the On/Off switch can be just spliced together, however then your lights will be on all the time. If you do like I did and only run lights off the high beam wires, then the low beam setting can be used as the Off switch.
The 2 wires running to the On/Off switch can be just spliced together, however then your lights will be on all the time. If you do like I did and only run lights off the high beam wires, then the low beam setting can be used as the Off switch.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)