Raptor starter won't engage?
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
It has been acting up for a couple of weeks now. The starter will spin, but will not turn the motor.
Is this the starter or the bearing that everyone has trouble with? With it in nuetral, I can push the bike and it sounds like something is rattling down in the transmission.
Thanks
Is this the starter or the bearing that everyone has trouble with? With it in nuetral, I can push the bike and it sounds like something is rattling down in the transmission.
Thanks
#2
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
Yes its the one way. Don't run it anymore till you swap it out. The one-way just shrapnels once it goes, so you probably have alot of junk in there. Change the one way and flush out the oil good before you ride again. I highly recommend the L&A one-way. If you buy the stocker your just gonna be replacing that too in a few months. [img]i/expressions/face-icon-small-mad.gif[/img]
#3
#5
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
yeah its deff the one way just if you are going to take it to the shop to do it watch out this kit should only cost under 200 bucks if its more dont get it. Its easy to do it yourself anyway just make sure you have the right tools. I also figured out that how much you pay the shop to do it ... If you just but every tool and do it yourself its so much cheaper and also next time it breaks you will have all the tools.
#7
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
check this out especially if you plan on doing it yourself, you don't even need the service manual if you use this site.
Click this for the one-way clutch installation guide
Click this for the one-way clutch installation guide
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)