Valve Clearances & Carb. Specs
#1
#3
I have a manual here for the 83-85 YTM/YFM 200 and 225.
The valve specs are: intake .05-.09mm (.002-.004 in) exhaust: .11-.15 mm(.0043-.006 in)
The float height is 21.5 mm (.85 in)
Compression should be 128 psi (+ or - 14 psi)
Main jet should be a 117.5
Main air jet is a 1.7
Jet needle is 4DH11 on the 3rd clip position
Needle jet is a N-6
Pilot jet is a 20
Pilot screw is set at 2 turns
This is right out of the manual for a YFM200DXS. There are different settings for a YFM200N if thats what you have.
The valve specs are: intake .05-.09mm (.002-.004 in) exhaust: .11-.15 mm(.0043-.006 in)
The float height is 21.5 mm (.85 in)
Compression should be 128 psi (+ or - 14 psi)
Main jet should be a 117.5
Main air jet is a 1.7
Jet needle is 4DH11 on the 3rd clip position
Needle jet is a N-6
Pilot jet is a 20
Pilot screw is set at 2 turns
This is right out of the manual for a YFM200DXS. There are different settings for a YFM200N if thats what you have.
Thread
Thread Starter
Forum
Replies
Last Post
1985, 200, carb, carburetor, clearance, clearances, moto4, setting, settings, specifications, valve, yamaha, yfm, yfm200, ytm
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)