I am not sure what I am looking for... I have stock rims on the back and have no idea what is the stock or how to measure a wheels offset??? I want to gain an inch of width on each side of the rear and a buddy said get wider offsets. I have heard good things about ITP beadlocks but I am not sure what the bolt pattern is on the rear either. I don't have a good answer from my local dealer and don't want to spend $250 on rims that are the same as stock. Any experts with some knowledge to share please do.

 

bolt pattern is 4/115. Stock wheels are 9x9, jut get some offset 3 in, 6 out wheels, or you can go with 10x10 wheels like me and get them offset to make it even wider. You could also just get some wheel spacers if you dont do much jumping. I was pushing 50in with my 5in spacers,10in wheels.

 

Thanks....So the stock ofset is 4 in, 5 out... That would make sense right.... I do way too much jumping to trust wheel spacers..is there such a thing as a 2 in, 7 out wheel or will I have to get a new axle for that kind of extra width?

 

new axle+offset .190 wheels is the ticket for you.

 

Check out Douglas Wheels web site, it explains the off set and how to order what you want.

 

For not much more than a couple wheels, you could get a wider, stronger axle. Just an idea.

RR1