Swingarm Bearings???
#1
Swingarm Bearings???
Are they hard to change on a Warrior? I got mine running(Stupid orange wire came off the igniton box) and the swingarm bearsing are bad...are these hard to change? Is it pretty much a lift the quad up, take the bolt out, and change the bearings? Or is it more complicated?....Please help em out here guys...or gals....thanks.
Later
Later
#3
Swingarm Bearings???
since no one is answering your post i will try to help you out the best i can. first you take the pivot bolt out. i would take the whole rear assembly of such as the axel, chain. to were you just have ur swingarm. then take out your bearings. if i were you i would use bearing removers/instalers. they are the only tool to use. i wouldent use anything differant. if u have a service manual it helps alot. that is a key thing to have. if u do not have on i would get one. also the bearing should come with instuction too. follow those. this is not much info but i hope it helps. good luck and ride safe
Thread
Thread Starter
Forum
Replies
Last Post
exmotocrosser
Polaris
10
09-13-2019 06:12 AM
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)