To all on this board.......
#1
To all on this board.......
Just a quick word to say THANK YOU. I decided to do some mods to my raptor and with the help from all that have posted their problems and all that have posted the solutions, I have had great success with the mods. My Raptor runs great. When I ran into a problem, I just came in and looked it up and read the solution. So, to all the people on this great board, I say thank you.
Some of you my already know this, but I didn't read anyone else having this problem.So I will pass a little knowledge on. When I finished my project and started it up, the valves sounded really bad. After setting them over and over with no improvement, I decided to take it back apart. With further inspection I found that I had put the decomp. shaft in 180 degrees out. The little plunger was stuck in the out position and thats why the valves sounded loose. So I redid it all, set the valves at 006 and 008 and it runs great.
Some of you my already know this, but I didn't read anyone else having this problem.So I will pass a little knowledge on. When I finished my project and started it up, the valves sounded really bad. After setting them over and over with no improvement, I decided to take it back apart. With further inspection I found that I had put the decomp. shaft in 180 degrees out. The little plunger was stuck in the out position and thats why the valves sounded loose. So I redid it all, set the valves at 006 and 008 and it runs great.