Wolverine Carb help.
#1
#3
Wolverine Carb help.
After you remove the carb, there should be a plate on the very top.Under that plate is your "piston" with an arm and a spring attatched. Remove the screw on the arm, opposite the side of the piston, rotate arm up and slide over. There are two screws atop the piston, undo those and the assy will be removable.Move clip up for lean and down for rich....Dont lose the small washer under the clip when you remove the needle. You can also go to ronnies.com for a microfiche diagram of your carb...
Thread
Thread Starter
Forum
Replies
Last Post
micheleLeigh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
07-12-2015 02:50 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)