Hi I have a 2004 Raptor. I just ordered an EHS lid for it and instead of going through a painful trial and error with the jetting I was wondering if anyone could tell me what they are running with their EHS. Right now I have a full Yoshi exhaust, pro-flow intake (with a foam filter), and am running a stage 2 Dynojet kit. I run a DJ 146 main in my left carb, and a DJ148 in the right. A DJ needle clipped on the 4th notch, and the mixture screws 3 turns out. I ride in WI and the elevation never really exceeds 1000ft above sealevel. My bike runs great with this set-up but now that I'm switching to that EHS lid, was wondering what jetting I'm gonna have to run. Thanks for any tips, I appreciate it.

Ben

 

Id go with 150/155. I would order 155-165 jets from DJ just to make sure youve got enough jets to try out. You might also wanna try 25 pilots with 2 turns out.

 

Thanks for the tips. I was also wondering about the pilot jets. Do I just buy the stock pilot jets for my carbs (just a bigger size), or do I need to buy Dynojet pilots?? Right now I'm running the stock pilots with the setup I have, but I'm pretty sure I'm gonna have to change them that's why I was wondering.

 

no need to get them from DJ, your dealer will have them