Looking to upgrade to aftermarket handlebars for the 660. Any suggestions? I was looking at the Tag T2's but i also dont feel like dropping $250 bucks. Are there any bars out there that will mount up to the stock hardware so I dont have to buy a new steerring stem or mouting kit?

 

Any 7/8" diameter bar will mount to your stock stem and clamps. Some may be too wide at the bottom and hit the tank though, this is dependant upon the bend and not necessarily the brand.

I'm a big fan of the Pro Taper SE bars and the FMF Factory 909 bars, but well under 100 bucks and both are very good.

 

I have the 909s as well. No complaints.

 

i like the renthal bars... they make one specificly for the 660 and so far have not bent or anything good set of bars for like 75 i think i payed

 

i have TAG T2 Low Bend bars with +2 LSR Stem and i like it alot and i didnt pay $250 i just traded a friend my renthals because the T2s were hitting his tank on an IMS 5.6 Banshee tank

 

I just bought the Pro Taper Bend Raptor Contour Handlebars from ridegear.com, with shipping they were like 70 bucks. I hope i dont have a problem with it hitting the gas tank or anything. We'll see!