WUS UP FELLAS I JUST got a 88 warrior and its been sitting for 7 months i got it home and the float was stuck so i took carb apart and soaked it in gas over night and im gonna clean jets and do u have any tips or tricks i should do before putting it back together????
thanx

 

Pull a peice of a wire brush's wire bristle out and use it to run through the pilot and main (make sure it's smaller than the hole and not reaming them out) This will remove any unwanted tarnish, then use a blow gun to blow them out and the holes they screw into. Use some scotchbrite to clean the needle and seat.

 

make sure the accellerator plunger is working properly. It is the plunger on the side of the carb if you remove the cover where the throttle cable goes in, and has a rubber boot around it. they hang up alot.