Anyone had to re-jet after installing a pro-flo and removing the stock snorkle? If so...please post the jetting changes required. Thanks in advance.

 

Assuming that is your only mod then try going from the stock 200 mains to 260's. You shouldn't need to mess with the needle or the pilots.

 

200 up to 260's? That sounds like way to big of jump, but I may be wrong. I did not have to rejet when I did my conversion to the Pro Flow... I am currently running 240's at 6000+ feet with the mods listed below. Try some 210 or 220's...

RoostKing...

 

It's not going to the pro-flo that makes the big difference. Pulling the snorkle off is what greatly increases the air-flow.

 

I already went from 200's to 220's on the mains. I was wanting to get a general direction in which to go on jetting or maybe someone had the exact same thing happen to them. I'll have to get a plug check and go from there. Thanks guys.