I'll make this request short, can someone look in their tech manual (wire schematic) and tell me what the solid BLUE wire in the harness coming from the stator is for ? I stuck a 99 wolverine motor in a 98 big bear and my original stator only had (4) wires in the harness and the wolverine has (5), the differenc being the solid blue wire, thanks in advance for any help.

 

anyone have a tech manual for a 99 wolverine hat they can look and see wha the blue wire is for ?

 

bump

 

stator wire 90% of the time are yellow and on most there is only three wire for a three phase stator.

 

I have a pdf manual shoot me an email ans I'll send it to you,

 

I think its the pulse genarator[trigger switch] for the flywheel location. this tell ign .system were the crank position is.

 

Sorry I couldn't email it to you, all of my email accounts limit files to 25mb. so I put it on a free upload site. here is a link:2shared - download LIT-11616-FX-37.pdf

When you click the link you'll go to the download page. You need to click where it says "save file to your pc" on the bottom of the page, right above a link that says "download 2shared toolbar"

Good luck, -Rich

 

thanks for the replys and down load, due to work i havnt had a ton of time to finish this restoration project but im getting close, actuall I need it done so i can plow my driveway. anyway in reguards to the blue wire, i do know that during cranking, there is no power on the blue wire,the remaining 4 wire all have power during cranking. so im not sure what the deal is.