Has anyone had to restring their pull start or can show me how to do it on a yamaha bear tracker. Maybe point me in the right direction. After i take off the front case is it hard to restring it or is it like a lawn mower which i have done before

 

i haven't had the honor of doing my grizzly's ripcord yet, but i did redo my polaris ripcord/pullstart. it's basically the same as a lawn mower. just make sure you get the spring "connected" and the load the spring. this polaris was a horrible experience. but i did learn a lot! good luck. make sure your knots are big enough not to pull through! i used flat washers and big big knots.