Yamaha Discussions about Yamaha ATVs.

shiekyurbooty

Thread Tools
 
Search this Thread
 
Old Jun 10, 2013 | 12:08 PM
  #1  
shiekyurbooty's Avatar
Thread Starter
|
Weekend Warrior
Joined: Jun 2013
Posts: 4
Likes: 0
Default shiekyurbooty

help, I have a 2006 450 Kodiak , runs real strong in 2 wheel and 4 wheel drive but when I push the dfif lock button to go into full time 4 wheel drive it's start to sputter and backfire and can't get more than 6kms an hour out of her, anybody out there with a similar problem, the diif lock engages I can here the servo doing it's thing but it runs out bad when locked into full time, anybody help me with this, thnx....
 
Reply
Old Jun 11, 2013 | 09:16 AM
  #2  
Oldbear's Avatar
Range Rover
Joined: Nov 2011
Posts: 146
Likes: 0
From: State Center, Iowa
Default

I have a 05 450 Kodiak the manual if you have one will tell you you'll have to hold in the kill switch on the left handle bar and may have to give it a few moments to engage as theres a limit control on it. Normally this is needed when you exceed 35 km. Also if the speedometer reads kinda screwey at this time there may be an electrical problem.
I know what you mean on this and mine will do it at a lot lower speed like yours until I remember the kill switch.
 
Reply
Old Jun 11, 2013 | 11:35 AM
  #3  
shiekyurbooty's Avatar
Thread Starter
|
Weekend Warrior
Joined: Jun 2013
Posts: 4
Likes: 0
Default

thank you sir, I will give it a go and see what happens
 
Reply

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 02:09 AM.