2001 Yamaha Warrior Wiring Problem
 

2001 Yamaha Warrior YFM350 - Was riding at lost trail in PA when it crapped out on me. Had a bad battery which had massive leaks, replaced it with a new one. One of my buddies suggested that the acid went straight through the harness. Had good compression and motor was running better than ever (new carb) and now it has no spark. Spark plug is fine. CDI possibly? Dont want to buy a new one and have that not be the problem. Any suggestions? Diagrams?

Do yourself a huge favor and got to tradebuit.com and buy a Factory yamaha repair manual for @ $10
The test and procedure you need will be in there

Did the battery split or boil? If it boiled, the regulator is faulty, you may get away with fitting a new regulator but it could also have cooked the CDI. beyondupnorth is right though, a good manual can save money on un-needed electrical components.

Most of the time no spark on a warrior ends up being a stator. If you have a OHM meter you can check the resistances on the plugs that come out of the stator. If you have any questions PM me and I can give you some help.

maybe you can help me i have a 91 warrior put new cdi rectifier stator coil on and it is not firing what could it be

And
 

Help on wiring

https://cimg5.ibsrv.net/gimg/atvconn...af06f98fa6.jpg
https://cimg7.ibsrv.net/gimg/atvconn...7943a1b4e1.jpgWher does the wires go...from relay..i bought this and just realized the headache im about to have where do wires go from starter solenoid..i know 1 goes to positve and does the ther go to starter motor. Or?...not getting fire just turning over..it crunk a few times now nothing just turning over..spark plug good