I want to have the head on my Banshee milled to get more low end power comparable to a Coolhead with 22cc or 21cc domes, I just cant see spending $280.00 on a coolhead when i can have the stock one milled cheap! My question is how much should I have it milled?

 

i have seen people mill 35 thousants and 40 thous. mine is milled 35

 

Thanks for the info Did you notice a difference in low end power? and how much did it cost?

 

Can you go the same amount on a Blaster?

 

For pump gas, .030 is a safe number on your Banshee. THis is an excellent and cheap mod. If you are not whether this can be done properly in your area....send it off. I sent my last stock head too Majic Racing in Michigan.

 

You can gain even more useable power if you play with the dome angle. This is almost as important as adding compression. If they change the angle, the amount that is removed from the deck varies. FTZ cut mine.

 

I recommend that you check your compression before and after you have your head milled. It's good to know how much of an increase you go and also you want to be sure the compression isn't too high.

 

some,and about $30

 

Ok thanks for the info.