I just orderd the JE 11:1 686cc piston kit and a hot cams stage two cam and valve springs and i dont know if i should go ahead and get a new rod or will my factory one be fine? If i should change the rod where can i find a good one? One more thing how much hp should i get out of this combination?

 

If you can do the rod I would, if you can't well.... I didn't. Carrilo for a rod.

 

factory rod should hold up... who are you getting to bore your cylinder
horsepower comes from the port work all you will need is clutch

 

I dont know who i am going to get to bore it yet there is a local place near me called bore tech that said they can do it so maybe there or maybe ill send it off some where any suggestions?

 

check you PMs