yesterday I was putting in my new durablue eliminator adjustable axle and found the stock axle to be adjustable also I was wondering if some ine had done this or it came from the factory like this. the way it is adjusatble is the same as my new durablue you take off the hub the there ius spacer's behind the hub and you can ad more spacers to widend or take some out to make it narrow I was wondering if all hondaq axle's are like this I haven't looked at 300ex's axle yet because it is in the garage in behind a bunch of stuff.


moded 86 TRX250r
moded 87 LT500R
97 300ex
96 warrior

 

I know mine isn't like that cause I noticed my hub was loose and when I before I tightened I took it off and checked everything out. no spacers or anything.

I never got any pics of your 250r.......boarder180@hotmail.com..later

 

250r axles have one little spacer in them so they are adjustable about an inch on each side.

 

Never noticed any ajustment on the 400ex but not sure about the 250r's. And if you would like a pic of b(250rman)'s quad I just got one up on my site. If anyone else would like their pics put up please send some, cause I would like to get a good visitors pics page going. Thanks.

 

The older Honda axles were adjustible. The 350X and 250R's come to mind.

 

hey we should trade quads.......
I have a couple pics of my 300ex before I put on my nerfs or works shocks.. http://photos.yahoo.com/big_air_300ex

 

hey how do I put in a link where all you gotta do is click on it? ya know where it has those red letters. ya'll let me know

 

You have to put www
I think

 

this address doesn't have www in it though..... let me try http://www.photos.yahoo.com/big_air_300ex

 

I know that the old atc 250r's and the 86-87 trx250r's had adjustable axles but they didn't produce them after that, and its a shame they didn't

89 250r with maier one piece plastic, sidewinder sprockets, fmf phatty exhaust, dg bumpers, wiseco piston, milled head, and 190 douglas wheels