If you're into drag racing, I just purchased a custom made wheelie bar for my atv. I guess they can make them for just about any racing atv machine. I tried it out...definately keeps my front end down on the start!! Should cut off precious seconds on my times.

 

where did u get them i need some for my trx 300 email it to mudvayne454@gmail.com

 

how much did it cost you?

 

where did you get the wheelie bar.

 

Guys, it isn't that difficult. Contact aircraft spruce and get some 3/4" .058 chromoly, 6 3/8" fine thread male heim joints, a go-kart wheel and take the bike and the chromoly to a welding shop.

Not a whole lot of science behind it. Lower heim joints will bolt to the carrier pinch bolts, and the upper heim joints will bolt to your grab bar mounts.