does any one know the stock needle and main jet size of a blaster? the year is 1994, i dont know if theychanged anything on the carbs over the years but.... ANY help would be greatly appreciated ----- i bought the quad w/ LRD head pipe and silencer.... was too loud for night riding so i went to put the stock pipes back on and there is NO AND I MEAN no top end..... i tried changing the jets before i even ran it stock pipes.... But i was given a baggy full of jets and i cant figure out the stock sizes of it. So it's totally incorrect, and not running to the correct standards ... any help PLEASE...

 

main 230
needle - 2nd clip
pilot - 32.5
screw 1-2 turns out

 

I was wanting to order some jets for a blaster, are the jets that you have the long or short hex? ( if you dont know could you measure the height of the hex section? Thanks

 

When you order them it should have a spot for you to select which quad they are for..You can get blaster specific ones.

 

I called white brothers but the guy there didnt know.

 

Just get a jet kit for the blaster.

 

That is a good suggestion however, I would like to buy a jet kit but the kits use dyno jets and their jets suck, egg shaped holes, burrs etc. I want to buy quality genuine mikuni, not the cheap imitation crap.

 

it's been a while since I have ran a mikuni but believe that they are the long hex head type.

 

I thought they where the long hex, just wanted some confirmation on that. Thanks