Does anyone know what groove the clip goes in on the needle jet on an 04 griz , putting carb and exhaust back to stock and didnt mark down what the stock setting was. Thanks greg

 

I guess I should start in the middle ?

 

Man dug this off the 3rd page, well I got my griz back to stock and I'll tell you I can still launch the front end with out pulling , even in hi range . I got a little tick I think from one of the exhaust valves it must be a hair loose. other than that it still has alot of power. Sounds like a tractor compared to my hmf exhaust. I also tried my dynatek Ign. it did seem to have a little more punch but I did not see if I had anymore top end. Maybe I will sell it . So in all of my aftermarket endevours I now know that I really did not need any of them, Maybe im getting older or just growing up, That was an expensive lesson. $$$$$$$$$$$$[img]i/expressions/face-icon-small-frown.gif[/img]