Well, I was cutting through a small treeline couple weeks back and tried to ride down a dead tree that wasn't quite as rotten as it looked. That's when I found out that the bumper is not a fully looped structure...and, oops, the plastic center cover is unsupported for about 8 or 10 inches. Straightening the plastic wasn't a problem: very careful use of a heatgun and some pressure = (almost) as good as new. Anybody know of a pre-drilled kit to reinforce this area???? (I'm not much of a welder, so that's kinda a last resort). Thanks in advance for any thoughts on this.