I had a +2 made out of my stock one, but I didn't measure my stock one before I took it in. I need to know so I can order the correct rise bars. I just need to know from the bottom plate where the tie rods connect up to the top of the welded plate that our bar clamps bolt to. So if someone has one laying around I would appreciate it.

Thanks,
Josh

 

29" bottom of lower plate to top of the top plate.

 

Thanks a million... my new stem is 31.25" + 1" for the clamp. Yikes, I am gonna have to get rid of my Flexx bars with a 4.6" rise and go to a 2.9", an RM Bend which is the lowest rise I can find in a ProTaper bar.