this is the second time it was replaced. once it was under warranty now i just replaced the second one. it was a pain to pull off i know there has to be a easier way. any suggestion for the next time it happens. it looks like a front wheel bearing seal on a car or truck but no way to knock it out that i can see. i had to get a screw driver and pry it out which was a pain for i was trying not to damage the inside wall. also trying to seat the seal was a bit of a pain the diff housing is soft metal and i was using a brass punch and it marked it up a bit trying to seat the seal. its all done now and it doesnt seem to leak. of course in s.communist block riding on the street can get u 40yrs of hard labor but i did take it for a spin on the street thx for suggestions

 

Rude-

save yourself a ton of heartache and frustration and get a factory service manual. Anywhere from 45 to 85 bucks, but it's worth it