Thumb Warmer - Need Advise
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I'm installing a Parts Unlimited thumb warmer. It has a soft rubber coated warmer. What's the best way to glue this to the throttle? Should I cut off the existing plastic on the throttle? Will glue bond better to the aluminum? I'm considering using super glue and filling the ends with epoxy. I want the cleanest look possible. I don't want to use zip ties around the element.
Any advise is greatly appreciated.
2002 500 Auto
Any advise is greatly appreciated.
2002 500 Auto
#2
#3
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I use heat shrink about an inch and 3/4 in diameter and about 2" long just slide it over the element and the thumb lever and hit it with a heat gun or hair dryer.Give the wire just enough slack to run the throttle and ziptie the wire to the handlebar.I've used it on at least 40 atv's with no complaints.
Thread
Thread Starter
Forum
Replies
Last Post
GirlsCan2
Technical and How-To Articles
0
08-27-2015 02:58 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)