Hey, my i just bought a DS, and the tire has a slow leak. While filling it up, we noticed the tires said either 36 or 3.6 PSI. My dad says its 36 and my freinds freind(lol) runs 3 to 4 PSI in all of his machines. What PSI should i run?????????????????

 

3 to 5 pounds

 

Definately NOT 36PSI! One peice of advice. Get yourself a good low pressure tire guage with a dial readout like this one. The one that comse in the factory tool kit is not worth beans.
http://www.cabelas.com/cabelas/en/te...&cm_ite=srchdx

 

3-5 is good I wouldnt put anymore then 8-10 at the very most, and for sure not 36.

And like dsengineer said get a good low pressure guage.

 

Definately 3-5 PSI. 36 PSI is probably the suggested PSI to seat the bead.

 

God help your kidneys if you manage to ride around with 36 lbs !!
Ill ride 3lbs in the rear and 5 lbs in the front and make sure that the air in the rears are the same for both sides.

 

That actually happened to a riding pal of mine. The 1st time he and I went riding I noticed somethingwas wrong, but I couldn't figure out what it was...I thought maybe his shock preload was way too high, or that his shock might have been siezed. I was looking at his bike, and leaned on the tire...it was as hard as a rock. I asked him what his psi was, and he said the side of the tire said 50 psi, so that's what he put in it. I told him that was to set the bead, and he freaked. He'd ridden it like that since he'd bought the bike. I lowered the PSI to around 3, and he said it was like riding a totally different bike. LOL