clearance on valves
#3
clearance on valves
ok i did a compression test earlier and got 100 lbs i didnt do anything with the decompression lever and i added 2 teaspoons of oil and got 170 psi so i thiught i had bad rings and started tearing it down, eagle gave me a bunch of info about it, thank god, i got everything lined up tdc and someone posted i should check my valve clearances that i might be that so i checked them and here they are the exhaust was,.005 on one and .006 on the other and i could not even get .0015 under either one of my intake valves for clearance, thats way too close right? but if the valves are out of clearance and i put a little oil in the cylinder and retest would the compression still increase or do i still have bad rings, thanks major, thanks for helping with the battery issue too, it is fixed and starts fine
Thread
Thread Starter
Forum
Replies
Last Post
Scooter's Shop
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
23
10-22-2015 07:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)